Looking for a company to produce some parts........

[Leebay]

Can anyone recommend or suggest any companies that would possibly make a run of automotive rubber insulators/carb to inlet pipes?!? I`ve emailed afew companies but no luck so far  

They`re quite small 40mm tall by 55mm long, 40mm diameter but they`ve got a two 10mm bolt hole flange on one end which takes a recessed o-ring.

[robrs2]

Can anyone recommend or suggest any companies that would possibly make a run of automotive rubber insulators/carb to inlet pipes?!? I`ve emailed afew companies but no luck so far  

They`re quite small 40mm tall by 55mm long, 40mm diameter but they`ve got a two 10mm bolt hole flange on one end which takes a recessed o-ring.

Are there no bike carb bits like that

[Mikey J]

Side draft webbers sometimes have runners that bolt in like this?  May be worth looking into.

[Janspeedcapri]

Why not cast copies yourself? Google and youtube will show you how and it'll cost next to nothing.

[Leebay]

Cheers for the response guys.

They are a obsolete Honda part from the old 80`s dual carbs. I`ve been given a complete set-up to strip and send off if necessary but I think I might have found a place in Petersfield just down the road just waiting for a call back.

Dont really have the time to knock some up myself.......did think about plasma cutting some flanges and metal tube to design a metal version with a striaght rubber coupling but I dont really have the time to do it atm.