Granada bits in sierra

[Rob01]

not sure if this is the right place , but say if i bought a Granada 2.9 12v and wanted to fit the engine into my sierra 1.6 what other parts would I need to source?

Thanks!

[Taps]

If you brought a complete granada nothing really

[Rob01]

well , its a complete car that I'm loking at the now , what about the fuel tank and bits on the sierra , its a single point innj 1.6 cvh btw

ta

[Taps]

Tank should be ok , fuel pump in it might need upgrading but could be fine will look up what pressures they run compaired to the 12V and let ya know

[Rob01]

Thanks

but what about the engine mounts

[Taps]

If there the same fitment as yours use the granny ones, if there not then fit the granny front crossmember

Right

Your 1.6 requires Fuel pump delivery pressure 0f 3 bar min

2.9 requires Fuel pump delivery pressure of 5 bar min

So you current pump might well not be up to the job, you can always swop the granny pump onto your set up, thats providing the granny one is a in tank pump, if its external then your need to change the tank to use the granny pump.

[Rob01]

Will an XR4i 2.8 box fit

This is the car

[Taps]

Rob is that an auto?

[Rob01]

yes sadly, will be a manual if i go ahead with the conversion

[Taps]

Ok, if you go 4i T9 then your need a 2.8 flywheel and clutch to go with it, cheaper way to go then going MT75, either box your need to fit a spigot bearing in the end of the crank.